Network

Quick Config Setup Guide

Hypervisor: 

Hypervisor

The hypervisor must be selected on the first network page.


Networking

Enter your network CIDR and the IPs for the gateway, the control panel and the compute nodes and click on the "Next" button.

Clicking on yes, the Quick Config Setup will show an info message with the following information.

Clicking on Yes, the process will continue. Then the IP addressing will be updated:


Once the settings are applied, a confirmation message will be displayed:


Click on the "Next" button and the connectivity checking process will automatically start running:


A confirmation message will show the connectivity test result:


Click on the "Next" button, to start checking if is there any new version:

 

In case a newer control panel version is available, the update process will automatically start running. Once this update is completed, the session will be closed and you'll be automatically redirected to the login page:


When you login in, the version is shown at the bottom of the page is 4.X.X


If the version is lower to 4.0.5, please refer to the Quick Config Setup guide - Upgrading to a newer version article.

Next, you can go to the Introduction section.

Related Questions

Copyright © Flexxible IT 2022, All Rights Reserved