SmartWorkspaces appliance Deployment for HP Proliant DL360

Flexxible|Appliance Deployment for HP

Physical Components

Connectivity

The document assumes that two (2) HPE ProLiant DL360 Gen 10 servers are available and connected to an independent switch without external connectivity.

Requirements:

  • It is necessary to connect four NICs to each node (Base-T or SFP+).
  • Each node must have two SSD disks with RAID 1 for the operating system and some SSDs for the virtual machines.
  • Burn the ISO installer file to SD Card.


Network

For the Ethernet 10 GB configuration, please follow this graph:

    

For the SFP+ configuration, please follow this graph:

 

ATTENTION! You will need to connect four NIC’s to each node (Base-T or SFP+) with interfaces UP before starting the deployment.

 

Users

Users to access to iLo:

  • Create customer profile user with administrator rights.
  • Customer profile password: last eight digits of the server serial number.
  • Create partner profile user with administrator rights.
  • Partner profile password: last eight digits of the server serial number.
  • User: administrator password: FlexxConsole25!


Disk Provisioning

This appliance counts with eight (8) disk slots for each node. The Smart Array controller manages all disks.

ATTENTION! System disks must be plugged in slots #1 and #2 of each node and the data disks must be plugged in any slot from the number 3 on. The system disks normally has a 240 GB capacity.


BIOS Configuration

The BIOS must have these settings configured with firmware 3.2.0.29 or earlier:

  • Date and time correctly set
  • SATA controller set in RAID mode.
  • SATA controller mode: EFI.
  • A RAID 1 volume created.
  • All disks marked as Solid State Drives.
  • Configure UEFI boot mode.
  • BIOS version U38 1.42
  • iLo: iLo 5 Firmware Revision 1.20
  • Hyperthreading enabled.
  • Fan set to full speed.
  • IPMI IP addresses:
  • Node A: 192.168.50.53 / mask: 255.255.255.0 / Gateway: 192.168.50.1
  • Node B: 192.168.50.54 / mask: 255.255.255.0 / Gateway: 192.168.50.1


The BIOS must have these settings configured with firmware 4.1 or newer:

  • Date and time correctly set
  • SATA controller set in RAID mode.
  • SATA controller mode: EFI.
  • A RAID 1 volume created.
  • All disks marked as Solid State Drives.
  • Configure UEFI boot mode.
  • Hyperthreading enabled.
  • Fan set to full speed.
  • IPMI IP addresses:
  • Node A: 192.168.50.53 / mask: 255.255.255.0 / Gateway: 192.168.50.1
  • Node B: 192.168.50.54 / mask: 255.255.255.0 / Gateway: 192.168.50.1
  • Firmware components:



System RAID setup

Power on Appliance and Press F9 Key for enter System Utilities:

Enter Sytem configuration:

Enter HPE Smart Array P408i-p SR Gen10:

ATTENTION! We must create a RAID 1 volume to install the system.








Virtualization - Max Performance


iLo default IP


Primary node
Secondary node

IP

192.168.50.53

192.168.50.54

Mask

255.255.255.0

255.255.255.0

Gateway

192.168.50.1

192.168.50.1